45User manual
Room air conditioner - TETA X
EN
PART 4. REMOTE CONTROL
NOTE: If you set the remote control in cooling mode, it will not be possible to activate the heating function in
units with a heating pump. If you need to reset, take out the batteries and install again.
3. You can program the temperature display between °C and °F.
1. Press and hold the
button over 5 seconds to get into the change mode
2. Press and hold the
button until it switch to °C and °F;
3. Then rele ng and wait for 5 seconds, the function will be selected.
NOTE
• Direct the remote control toward the Air conditioner.
• Check that there are no objects between the remote control and the Signal receptor in the indoor unit.
• Never leave the remote control exposed to the rays of the sun.
• Keep the remote control at a distance of at least 1m from the television or other electrical appliances.
To Next Page
Loading...
