Rotenso TM35X - Display Function (Indoor Display); Health Function (Optional); I Feel Function; Sleep Function

49User manual
Room air conditioner - TETA X
EN
PART 5. OPERATING INSTRUCTIONS
14. DISPLAY function (Indoor display)
Switch ON/OFF the LED display on panel.
Press button to switch o the LED display on the panel. Press again to switch on
the LED display.
15. SLEEP function
Pre-setting automatic operating program.
Press button to activate the SLEEP function, and appears on the display. Press
again to cancel this function.
After 10 hours running in sleep mode, the air conditioner will change to the previous
setting mode.
16. I FEEL function
Press button to active the function, the will appear on the remote display.
Do it again to deactivate this function.
This function enables the remote control to measure the temperature at its current
location, and send this signal to the air conditioner to optimize the temperature around
you and ensure the comfort.
It will automatically deactivate 2 hours later.
18. WINDLESS function (Optional)
1. Turn on the indoor unit, and change to COOL mode, then long press and button together
3 seconds to active this function, will appear on the display.
Do it again to deactivate it.
2. This function will auto close the vertical aps, and give you the comfortable gentle wind feeling.
19. HEALTH function (Optional)
1. Turn on the indoor unit at rst, press to active this function, will appear on the display.
Do it again to deactivate it.
2. When the HEALTH function is initiated, the Ionizer/ Plasma/ Bipolar Ionizer/ UVC Lights (depending on
models) will be energized and running.