Rotenso WINDMI Series - Page 41

41User manual
Wired control - ORIS
EN
No. Item Description
0 Clock setting
1. Press the “setting” button, then press “conrm” button to enter day setting,
then press “up” or “down” button to change the day if necessary;
2. After day stetting, press the “conrm” button to enter hour setting, press
“up” or “down” button to set the correct time in hour;
3. After hour stetting, press the “conrm” button to enter minute setting,
press “up” or “down” button to set the correct time in minute;
4. Press “conrm” button to conrm and exit clock setting.
You can also press “setting” button to go to next parameter.
1 Schedule of DHW
1. Press and hold the “conrm” button, the icon “on” will be ashing, then press
the “conrm” button to conrm, the icon “on” will be constant lighting;
2. Press and hold the “down” button to enter day setting, then press “up” or
“down” button to select the day, press the “conrm” button to conrm day
setting, after that, the icon of that day will be constant lighting;
3. Press and hold the “down” button to enter hour setting, then press “up” or
“down” button to select the time in hour, press the “conrm” button to conrm;
4. Press and hold “down” button to enter minute setting, then press “up” or “down”
button to select the time in minute, press the “conrm” button to conrm;
5. Press and hold “down” button to set the timer o, then press the “down” button
to enter hour setting, then press “up” or “down” button to select the time in
hour, press the “conrm” button to conrm;
6. Press and hold “down” button to enter minute setting, then press “up” or “down”
button to select the time in minute, press the “conrm” button to conrm;
7. Press and hold “conrm” button to conrm and exit user setting. You can also
press “setting” button to go to next item.
2
Power memory
setting
This is used to record the setting once power is shutdown, and system will
recovery the previous status once power come back.
Press “up” or “down” button to set the value;
0 - With power memory (default);
1 - Without power memory
3 WIFI statue Reserved
4 Air purge mode
Press the “up” or “down” button to set the value;
0 - Not start air purge mode
1 - Start air purge mode
If choose 0, then press the “setting” button to go to next item;
If choose 1, then press the “conrm” button to exit the setting and unit will
start the air purge mode; during the air purge mode, wired controller will be
displayed “P only the “ON/OFF” button are valid to exit this mode.
5
Occupancy mode
setting
1. Press “up” or “down” button to set the value;
2. Then press “conrm” button to conrm and exit user setting or you can also
press “setting” button to go to next item.
0 - Home;
1 - Eco;
2 - Away