Rotex Posidapt Series - Page 107

RTX-IOM-PRODUCT-YY
Page 107 of 131
www.rotexautomation.com
The device triggers a fault message if set point change average value exceeds set
threshold value. The value can be set up to 100000000.
Average Direction Change
This parameter is used to calculate and monitor the average direction change.
• Off
This parameter value does not trigger any message or alarm.
• Custom
The device triggers a fault message if average direction change value exceeds set
threshold value. The value can be set up to 100000000.
Average Direction Change in Steady State
This parameter is used to calculate and monitor the average direction change in steady
state.
• Off
This parameter value does not trigger any message or alarm.
• Custom
The device triggers a fault message if average direction change steady state value exceeds
set threshold value. The value can be set up to 100000000.