www.rotexautomation.com
▪ Pressure
Applicable for Posidapt – Super, Ultra and IPST
This parameter is used to set the pressure unit. The selected temperature unit is then also
applicable for all other pressure-based parameters.
• bar– Factory default
This sub-parameter value sets the pressure unit to bar.
• psi
This sub-parameter value sets the pressure unit to pound per square inches.
• kPa
This sub-parameter value sets the pressure unit to kilo Pascal.
• kg/cm
2
This sub-parameter value sets the pressure unit to kilogram per square centimetre.
To Next Page
Loading...