www.rotexautomation.com
This parameter is used to limit the mechanical travel of the zero point (start point) of actuator.
• Off -Factory default
In this mode the start (zero) mechanical position is the same as the actual start position of
the actuator determined during auto calibration.
• Custom
The start (zero) position can be configured to desired value. This allows limiting the start
(zero) position of actuator. The value can be set from 0.0 to 100.0%.
End Point Soft Stopper
Applicable for Posidapt – Modern, Expert, Super, Ultra and IPST
To Next Page
Loading...