www.rotexautomation.com
This parameter is used to cut off unusable range of the control valve from the point of control.
• Off
In this mode the valve will follow the input signal linearly. The valve end position is same as
the actual end position of the actuator determined during auto calibration.
• Custom
This parameter is used to cut off end position (100.0%) unusable range of the control valve.
It is the percentage of the working range to which to which the valve is moved with minimum
input signal to move valve reverse.
The value can be set from 100.0 to 80.0
Zero Point Soft Stopper
Applicable for Posidapt – Modern, Expert, Super, Ultra and IPST
To Next Page
Loading...