www.rotexautomation.com
This parameter defines the magnitude of the permissible pressure difference from the
recorded value.
• Off
This parameter value does not trigger any message or alarm.
• Custom
The threshold 2 fault message is displayed when the limit threshold 2 is exceeded. The value
can be set from 0.0 to 10.0 bars.
Threshold Limit 3
This parameter defines the magnitude of the permissible pressure difference from the
recorded value.
• Off
This parameter value does not trigger any message or alarm.
• Custom
The threshold 3 fault message is displayed when the limit threshold 3 is exceeded. The value
can be set from 0.0 to 10.0 bars.
Lower Temperature Monitoring
Applicable for Posidapt –Super and Ultra
This parameter is used to continuously monitor the minimum temperature recorded inside the
enclosure. The current temperature in the enclosure is recorded by a sensor on the main
circuit board.
The minimum temperature recorded is displayed in the “Minimum temperature recorded”
diagnostics parameter. The device triggers a fault message if the current value undershoots
one of the three configurable limit thresholds.
To Next Page
Loading...