www.rotexautomation.com
Threshold Limit 1
This parameter is used to set the temperature threshold 1. The device triggers a fault
message if the current temperature inside the enclosure undershoots threshold 1.
• Off
This parameter value does not trigger any message or alarm.
• Custom
This sub-parameter value is used to monitor the lower limit temperature. Set the threshold in
a range from "- 60.0 °C" to "130.0 °C" or "- 76.0 °F" to "266.0 °F".
Threshold Limit 2
This parameter is used to set the temperature threshold 2. The device triggers a fault
message if the current temperature inside the enclosure undershoots threshold 2.
• Off
This parameter value does not trigger any message or alarm.
• Custom
This sub-parameter value is used to monitor the lower limit temperature. Set the threshold in
a range from "- 60.0 °C" to "130.0 °C" or "- 76.0 °F" to "266.0 °F".
Threshold Limit 3
This parameter is used to set the temperature threshold 3. The device triggers a fault
message if the current temperature inside the enclosure undershoots threshold 3.
• Off
This parameter value does not trigger any message or alarm.
• Custom
This sub-parameter value is used to monitor the lower limit temperature. Set the threshold in
a range from "- 60.0 °C" to "130.0 °C" or "- 76.0 °F" to "266.0 °F".
To Next Page
Loading...