www.rotexautomation.com
Threshold Limit 3
This parameter is used to set the pressure threshold 3. The device triggers a fault message
if the current inlet pressure undershoots threshold 3.
• Off
This parameter value does not trigger any message or alarm.
• Custom
This sub-parameter value is used to monitor the lower limit pressure. Set the threshold in a
range from "0.0" to "10.0" bar.
High Pressure Monitoring
Applicable for Posidapt –Super and Ultra
This parameter is used to continuously monitor the maximum value of supply pressure
recorded. The current inlet pressure is recorded by a pressure sensor on the main circuit
board.
The maximum recorded value is displayed in the “Maximum pressure recorded” diagnostics
parameter. The device triggers a fault message if the current value overshoots one of the
three configurable limit thresholds.
Threshold Limit 1
This parameter is used to set the pressure threshold 1. The device triggers a fault message
if the current inlet pressure overshoots threshold 1.
• Off
This parameter value does not trigger any message or alarm.
• Custom
This sub-parameter value is used to monitor the higher limit pressure. Set the threshold in a
range from "0.0" to "10.0" bar.
Threshold Limit 2
This parameter is used to set the pressure threshold 2. The device triggers a fault message
if the current inlet pressure overshoots threshold 2.
• Off
This parameter value does not trigger any message or alarm.
To Next Page
Loading...
Need help?
General