Need help?Do you have a question about the rotork CML-250 and is the answer not in the manual?
Critical flamepath dimensions for ATEX & IECEx approved actuators, ensuring safe use.
Consolidated warnings: electric shock, ESD, enclosure, operating hazards, and RPP safety.
Steps for commissioning, tools, and safety notes including RPP and display status.
Steps for mounting CML actuators and associated safety precautions.
CMQ mounting, safety precautions, and stop bolt adjustment.
Guidelines for CMR mounting, drive coupling, and aligning the actuator.
General electrical installation guidance, safety precautions for cover removal.
Introduction to basic setup, listing sequential steps and button functions.
Step-by-step guide to setting the actuator to Local Operation mode.
Instructions for adjusting actuator output torque or thrust for safe setup.
Configuring actuator action at end of travel: limit or force.
Step-by-step guide to setting the actuator's closed end of travel limit.
Step-by-step guide to setting the actuator's open end of travel limit.
Explains automatic calibration of 4-20 mA signal for the closed limit.
Procedure for calibrating span setpoint using an external 4-20 mA signal.
Final steps: setting to remote mode and refitting the cover.
Critical flamepath dimensions for ATEX & IECEx approved actuators, ensuring safe use.
Consolidated warnings: electric shock, ESD, enclosure, operating hazards, and RPP safety.
Steps for commissioning, tools, and safety notes including RPP and display status.
Steps for mounting CML actuators and associated safety precautions.
CMQ mounting, safety precautions, and stop bolt adjustment.
Guidelines for CMR mounting, drive coupling, and aligning the actuator.
General electrical installation guidance, safety precautions for cover removal.
Introduction to basic setup, listing sequential steps and button functions.
Step-by-step guide to setting the actuator to Local Operation mode.
Instructions for adjusting actuator output torque or thrust for safe setup.
Configuring actuator action at end of travel: limit or force.
Step-by-step guide to setting the actuator's closed end of travel limit.
Step-by-step guide to setting the actuator's open end of travel limit.
Explains automatic calibration of 4-20 mA signal for the closed limit.
Procedure for calibrating span setpoint using an external 4-20 mA signal.
Final steps: setting to remote mode and refitting the cover.
General| Brand | rotork |
|---|---|
| Model | CML-250 |
| Category | Controller |
| Language | English |
To Next Page
