Need help?Do you have a question about the rotork CMQ-250 and is the answer not in the manual?
Specific conditions for safe use of ATEX/IECEx certified actuators.
Consolidated key safety warnings and precautions for installation and operation.
Detailed instructions for installing the actuator.
Information about the Reserve Powerpack feature and its operation.
Instructions for mounting the CML linear actuator.
Mounting procedure for CMQ quarter-turn actuators.
Procedures for adjusting stop bolts on CMQ actuators.
Mounting instructions for CMR rotary actuators.
Detailed electrical installation procedures and precautions.
Guidelines for routing and terminating installation wiring.
Introduction to the basic setup procedure for the actuator.
Steps to select and configure local operation mode.
Continuation of selecting and configuring local operation mode.
Procedure for setting the actuator's output torque or thrust.
Continuation of setting actuator output torque or thrust.
Configuring the actuator's action at the end of travel.
Continuation of configuring end of travel action.
Procedure for setting the closed limit of travel for the actuator.
Procedure for setting the open limit of travel for the actuator.
Calibrating the zero setpoint for the command signal.
Calibrating zero setpoint with an external 4-20 mA signal.
Specific conditions for safe use of ATEX/IECEx certified actuators.
Consolidated key safety warnings and precautions for installation and operation.
Detailed instructions for installing the actuator.
Information about the Reserve Powerpack feature and its operation.
Instructions for mounting the CML linear actuator.
Mounting procedure for CMQ quarter-turn actuators.
Procedures for adjusting stop bolts on CMQ actuators.
Mounting instructions for CMR rotary actuators.
Detailed electrical installation procedures and precautions.
Guidelines for routing and terminating installation wiring.
Introduction to the basic setup procedure for the actuator.
Steps to select and configure local operation mode.
Continuation of selecting and configuring local operation mode.
Procedure for setting the actuator's output torque or thrust.
Continuation of setting actuator output torque or thrust.
Configuring the actuator's action at the end of travel.
Continuation of configuring end of travel action.
Procedure for setting the closed limit of travel for the actuator.
Procedure for setting the open limit of travel for the actuator.
Calibrating the zero setpoint for the command signal.
Calibrating zero setpoint with an external 4-20 mA signal.
General| Brand | rotork |
|---|---|
| Model | CMQ-250 |
| Category | Controller |
| Language | English |
To Next Page
