Page 6 of 33
in-hypalm-v40 / 20051205
HygroClip Digital Probes
The HygroPalm is primarily designed for use with the ROTRONIC HygroClip digital humidity temperature
probes. These probes permit to take full advantage of all the features and functions of the HygroPalm.
The ROTRONIC HygroClip digital probes are highly accurate and are calibrated entirely by means of
software (no adjustment potentiometers). Because calibration and other data are stored in the probe non-
volatile memory, the probes are fully interchangeable. When a probe requires calibration or has to be
repaired, it can be replaced with another probe in a few seconds.
The ROTRONIC HygroClip digital probes are available in different configurations so as to meet the
requirements of each application:
Note: the above probes have a 5-pin DAT-05 connector
HygroClip S
measurement in air
max. 85°C (185°F) – wire mesh filter
HygroClip SP05
measurement in air ducts
max. 85°C (185°F)
HygroClip SC05
measurement in tight spaces
max. 100°C (212°F)
HygroClip HK25 / HK40 air probe
measurement at high temperature
HK25: max. 150°C (302°F)
HK40: max. 200°C (392°F)
wire mesh filter
HygroClip HP28 insertion probe
measurement of materials in bulk
max. 85°C (185°F)
sintered steel filter
HygroClip HS28 sword probe
measurement of paper stacks/rolls
max. 85°C
To Next Page
Loading...
Need help?
General
