ROVE R3 - Page 18

Now thoroughly clean the
applicable area using the
included cleaning pad and
let it air dry.
3
Now peel off the “Step 1” side of the electrostatic film & apply
the exposed static side to the windshield. Apply pressure to
the film, Use credit card to slide and remove any air bubbles
for the strong bond with the windshield.
4
NOTE:
When applying the electrostatic film on the car's windshield, avoid the car's
dot matrix pattern for the sun block. Once you apply “Step 1” side to the
windshield, before removing the “Step 2” side of the electrostatic film, ensure
all the bubbles are removed properly by using the credit card to slide them
out. NowdoNOT peel the back side of the electrostatic film yet. Wait until you
are ready to apply the 3M StickyMount in the middle of the electrostatic film.
Do NOT touch the area after cleaning, or finger grease will not allow the
electrostatic film to create a strong bond with your windshield.
CAUTION:
After you peel off the top film, do NOT touch the applicable side of the
electrostatic film with fingers to test it. It is charged with electric particles
to create static bond. No need to touch it to test how strong it is.
CAUTION:
Avoid this
dot-matrix pattern
as the electrostatic
film will NOT stick
properly over the
bumpy pattern.
18
USER MANUAL