ROVE R3 - Page 19

Now, let's peel off the back side of the electrostatic film's cover,
doNOTtouchthe middle where you will be sticking the 3M
tape/ROVE R3 mount.
6
Now, let’s make sure the 3M Mount is fully secured and
locked in place. Make sure there is NO Gap
(See photo below)
5
Attach the sticky mount to the front/main camera securely and ensure
that it doesn't have a gap in between (as seen in the photo above).
Otherwise, the camera will have a power supply (Rebooting) or NO GPS
signal issue.
IMPORTANT:
Right
Wrong
19