PRIMARY
CHAIN
ADJUSWENT
The chain should be adjusted.
so that there is
1
/4" up and
down movement at the centre of
the top run of the chain.
Remember to
check the chain
tension at
3
or 4 places and then
adjust accordingly. Ensure that
the chain tensioner pad moves
freely and the lock nut of the
adjuster is retightened after
carrying out the adjustment. The
chain is to be renewed if its
length has increased by
3/4"
than the length of a new chain.
After replacing the chain
cover. remember to replenish the
chaincase with oil
[SAE
20) up
to the
leve1,plug in outer chain
case[approx
-
Qty..
-
430 to 450
14.
Adjustment of the Clutch control
It is essential that there should be about
3
to 4mm free movement in the clutch cable. to
ensure that
all
the spring pressure is exerted on the plates.
There are two
~oints of adiustment on the clutch cable. The first is the midway adjuster at
A
CillTCH
ADJUSWEhT
ON
GEAR
BOX
the middle of the cable just above the
chain case. The adjustment is made by
screwing the adjuster screw in or out of
the adjuster body. Tighten the
locknut on
the screwed collar after adjustment has
been made.
The other point is at the handle bar
end. Loosen the lock nut and
thread
in
the adjuster to increase play and vice
versa to reduce play. Tighten lock nut
after carrying out adjustment.
Homver
if the adjusters have reached their
maximum position then the adjustment
can
be carried out
in
the gear box outer
cover. Before proceeding on the
adjustment, turn in both cable adjusters
to their fully closed position [fully in
position).
To make the adjustment, remove the inspection cover, slacken the
locknut and turn the
central screw
in,
to get the desired free play on the clutch lever at the handle bar end. Tighten
-
the locknut after adjustment has been made.
To Next Page
Loading...
Need help?
General
