EasyManuals Logo

RPS CONDOR 150 User Manual

RPS CONDOR 150
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
11
BREAKING IN THE ENGINE
The first 30~50 Miles of operation should be considered the “Break-in” period and special attention shall be
paid to the following points:
1. Take special care not to increase the RPM’s of the engine while climbing steep slopes. Never drive your
motorcycle continuously for more than 50km (30 miles) without increasing and decreasing the throttle.
2. The engine shall be warmed up for 3-5 minutes prior to operation so all components are lubricated
sufficiently.
3. The driving speed shall not be over 40 kmph (25 MPH) maximum during the first 500 km (300 miles) of
operation and not over 65 kmph (40 MPH) maximum during the remaining 500 km (300 miles) of the
“Break-In” period.
SWITCHES ON RIGHT HANDLEBAR
Ignition switch
The ignition switch is Located on the right handlebar.
When the switch is turned to
(off) position, the engine will not start. If the engine is running and the
Off button is pushed the engine will turn off.
When the switch is turned to
(on) position, the engine can start by using the electric start or kick
start lever.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RPS CONDOR 150 and is the answer not in the manual?

RPS CONDOR 150 Specifications

General IconGeneral
BrandRPS
ModelCONDOR 150
CategoryMotorcycle
LanguageEnglish

Related product manuals