3
SAFE OPERATION
A pre-operation check must be conducted before starting the engine.
This check will insure safety, prevent mishaps, and prevent damage to components.
It is strongly suggested that all operators take a certified motorcycle rider’s course prior to operating the
vehicle.
Full attention is required during driving; paying close attention to the following points to avoid any injury to
you by other motorized vehicles:
• Do not drive too close to other vehicles.
• This motorcycle is for one operator only.
• Driving at high speeds is the cause of many accidents; do not drive at a speed that the actual situation
does not permit.
PRE-RIDE CHECKLIST
1. Engine oil level
a) Check for leaks
b) Tighten filler cap securely.
c) Add oil if required.
2. Fuel level
a) Add fuel as necessary.
b) Do not overfill (no fuel in the filler neck).
c) Do not mix oil with gas.
d) Replace cap tightly.
e) Do not refuel a hot engine. Allow engine to cool before adding fuel.
3. Warning decals
a) Make sure all warning decals are legible and securely attached.
b) Replace as necessary.
4. Tires
a) Ensure that both tires are in safe riding condition.
b) Properly inflate both tires. We recommend that you inflate the tire to between 15psi and 20osi. Do not
exceed 32 psi.
5. Drive chain
a) Check condition and tension.
b) Lubricate and adjust tension as necessary.
6. Throttle
a) Check for smooth operation. Make sure the throttle “snaps” back to idle.
To Next Page
Loading...
Need help?
General
