24
RESUMPTION OF SERVICE AFTER STORAGE
1. Remove the covering and remove the wooden blocks used in storing the vehicle. Change the engine oil
if the vehicle has been out of service for over 4 months.
2. Drain off the remaining atomized anti-rust oil from the fuel tank, followed by filling it with fresh gasoline
therein.
3. Prior to driving, all the required check-ups must be made. It is better to drive it at a low speed in an
open area to test its performance before normal operation.
TABLE OF TORQUE OF FASTENERS
Ser.
No.
Fastener
Torque (Newton/m)
(Foot/lb)
1 Nut for tightening upper joining plate of front fork with vertical tube 40~50Nm (30~37 ft.lb.)
2 Nuts for fixing engine 20~25Nm (15~18 ft.lb.)
3
Bolt for tightening upper joining plate of front fork with shock
absorber
15~20Nm (11~15 ft.lb.)
RESUMPTION OF SERVICE
1. Remove the covering and clean the vehicle. Change the lubricating oil if the vehicle has been off service
for more than 4 months.
2. Drain off the anti-rust solution from the fuel tank, followed by filling fuel therein to the required level.
3. Prior to driving, test the vehicle at a low speed in a safe place.
INSPECTION AND MAINTENANCE
It is very important to inspect and maintain your motorcycle regularly.
Follow the guidelines in the chart. The intervals between periodic services in months are shown. At the end
of each interval be sure to perform the maintenance listed.
To Next Page
Loading...
