EasyManuals Logo

RPS CONDOR 150 User Manual

RPS CONDOR 150
33 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
21
IGNITION SYSTEM CHECK
1. Remove the spark plug and reattach it to the spark plug lead.
2. Turn ignition key to the “RUN” position. Slide the engine stop switch to the “Run” position. Push the
start button.
If the ignition system is operating properly, a blue spark should jump across the spark plug gap. If there is
no spark, take your machine to your dealer.
WARING
Preforming the spark test improperly could be hazardous.
You could get a high voltage electrical shock if you are not familiar with this procedure.
Do not perform this check if you are not familiar with the procedure.
Do not point the spark plug near the spark plug hole during this test.
Do not do this test if you have a heart condition or wear a pacemaker.
Do not perform this test is any near any open fuel containers for near fuel which has spilled on the
ground, on the engine, or any part of the motorcycle.
COMPLAINT: Engine stalls
1. Make sure there is enough fuel in the fuel tank.
2. Check to see that the spark plug is not fouled. Remove the spark plug and clean it. Replace it, if
necessary.
3. Make sure the fuel valve is not clogged, and the fuel tank is not clogged, either.
4. Check the idle speed. If necessary, adjust it using a tachometer. The correct idle speed is
1500±150r/min.
5. Make sure the air filter is clean.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the RPS CONDOR 150 and is the answer not in the manual?

RPS CONDOR 150 Specifications

General IconGeneral
BrandRPS
ModelCONDOR 150
CategoryMotorcycle
LanguageEnglish

Related product manuals