the shroud adjuster plate.
To rig the jib:
1) Unroll the jib.
2) Take the tail of rope sewn into the tack of the jib, and pass it through the metal
loop on the tack bar.
3) Pass the tail through the webbing loop sewn onto the tack of the jib.
HINT
The mast on the RS Feva is supported at deck level by the mast gate and the
foredeck. The shrouds are fitted to stop the mast from bending when tension is
applied to the jib halyard, hence making the jib work better. Therefore, changing
the shroud adjuster hole position will affect the amount that the mast bends when
tension is applied to the jib halyard.
To Next Page
Loading...
