RSP Compact Series - Replacement of Signal Pins (Electric Versions Only)

M0416-1 version 3.2 19
4.3.3 Replacement of signal pins (electric versions only)
5
Action
Note
1
Power off
Switch the power off and lock the
circuit breaker.
2
Remove signal pins
Pull out the signal pins with a pair
of pliers.
3
Replace signal pins
Fit the new signal pins by pushing
them into the sleeves.
NOTE! The signal pins should be
fully pressed into the sleeve using
a small screwdriver.
4
Power on
Unlock the circuit breaker and
switch the power on.