OLED disabled (menu is still active). Status LED dim.
Short cut which flips (reverses) the MAIN KNOB rotation.
Wireless settings. The RECEIVER (if powered on) will copy.
Select Controller transmission power.
Maximum Range legal in USA.
Maximum Range legal in EU and most of the world.
Medium Range (best balance of range and battery life).
Required when very close to camera. (Default)
Force the wireless module to reboot.
Configure the physical knobs/ slider on the controller.
Which INPUT (Knob, Slider) should control which AXIS (Focus,
Iris) ?
The FOCUS axis is controlled by KNB, i.e. main knob.
The IRIS axis is controlled by SLI, i.e. the slider.
Flip the direction of INPUTS. i.e. make the lens rotate in REVERSE.
The main knob is set to FLIP mode (reverse).
The slider is NOT set to flip.
Reconfigure the physical stops for the MAIN KNOB. If you are
unable to reach the end of the lens travel, run this function.
Configure the auxiliary port on the RECEIVER.
What function to assign to the AUX PORT?
Disable the AUX port. Recommended if port not in use.
Configure AUX port for WIRED MODE (i.e. wire from Controller ->
Receiver to bypass radio).
You have a KNOB or THUMBWHEEL attached to the AUX PORT.
You have a ROCKER attached to the AUX PORT.
You have a FORCE SENSOR attached to the AUX PORT.
Which axis to control with the attached AUX input device? N.B.
This does not apply if you are in WIRED MODE.
As “Mode” above, but for input axis B (for use with splitter).
As “Axis” above, but for input axis B (for use with splitter).
To Next Page
Loading...