Assign a function to the physical UP button.
Assign a function to the physical DOWN button.
Assign a function to the physical SET button.
Assign a function to the physical POWER+UP button combination.
Assign a function to the physical POWER+DOWN button
combination.
Assign a function to the physical POWER+SET button
combination.
Advanced functions for debugging and technician use only.
Change the Serial # of the handset (not recommended).
Take the CONTROLLER back to factory default settings. This DOES
NOT roll back the firmware version. It also does not change the
settings stored inside the motors (class, response, etc.)
Raw read-outs to use for diagnosing issues.
Enable/Disable the radio. (Radio is automatically disabled when
wired mode is used).
13 Technical Reference
Compatibility Guidance
Motors
All MK3.x generation motors will work with any MK3.x generation Controller/Receiver sets.
Controller / Receiver Sets – RF3
Controllers and Receivers must be of the same “RF” generation.
MK3.0 Controller/Receiver sets have RF2 generation wireless modules and have been
obsoleted. Upgrade routes are available, please contact RTMotion for details.
MK3.1 Controller/Receiver sets and LATITUDE units have RF3 generation wireless modules.
MK2 and MK3 generation systems.
These systems are now “end-of-life”. We will strive to support them as long as possible, but we
recommend that these systems are upgraded to the present generation to ensure the best support.
To Next Page
Loading...