12 Menu Tree (via Controller)
This is a short-cut to the MOTORS > RECALIB menu (below).
Select which CAMERA is attached to the RECEIVER.
ARRI Alexa (RS socket). Mini requires EXT-RS Adapter
RED DSMC2 (CTRL socket).
For cameras which record while trigger is "held low".
For Blackmagic, Sony FS700, etc.
Configure ATTACHED MOTORS.
RECALIBRATE one or more MOTORS.
Recalibrate all attached motors.
Recalibrate motor by CLASS (e.g. Focus, Iris, Zoom).
Manually calibrate end stops for a motor/lens.
Adjust MOTOR RESPONSE. This setting is stored inside the motor.
Slightly smoothed for elegant moves. (Default)
Very smoothed, useful for Iris or Zoom.
Very sharp response. Very low latency.
Reassign a MOTOR to a particular class, e.g. Focus, Iris... This
setting is stored inside the motor.
Change the internal serial number of a motor. This setting is
stored. inside the motor.
Alter motor’s factory calibrated backlash compensation. Attach
the motor to a lens and then run this routine. Adjust the number
until the motor reaches the same point from both directions. This
usually around 10. Please note that your mount should be very
rigid.
Full brightness for daytime. Status LED also bright.
Low brightness for night/indoor. Status LED dim.
To Next Page
Loading...