J Line Pump
Horizontal Double Suction Centrifugal Pump ā API 610 Process Pump
57 V1.032818
RADIAL (COUPLING SIDE) BEARING
28. Unbend the tab of the radial bearing lock washer from the groove of the radial bearing lock
nut.
29. Remove the radial bearing lock nut.
30. Remove the radial bearing lock washer.
31. Remove the radial oil ring.
32. Remove the radial bearing sleeve.
33. Remove the radial bearing.
34. Remove the internal radial bearing housing cover.
35. Remove the radial bearing spacer.
RADIAL (COUPLING SIDE) MECHANICAL SEAL
36. Remove the hex bolts that secure the radial mechanical seal to the radial casing cover.
37. Remove the radial mechanical seal.
AXIAL (NON-COUPLING SIDE) CASE COVER
38. Remove the axial throat bushing.
39. Remove the hex nuts that secure the axial casing cover to the case.
40. Remove the studs that join the axial casing cover to the case.
41. Remove the axial casing cover.
RADIAL (COUPLING SIDE) CASE COVER
42. Remove the radial throat bushing.
43. Remove the hex nuts that secure the radial casing cover to the case.
44. Remove the studs that join the radial casing cover to the case.
45. Remove the radial casing cover.
To Next Page
Loading...
