J Line Pump
Horizontal Double Suction Centrifugal Pump – API 610 Process Pump
60 V1.032818
ROTOR
1. Insert impeller key in the shaft’s central keyway.
Figure 8.1. Inserting the impeller key in the shaft’s central keyway.
2. Insert the shaft, starting from the coupling side, through the impeller. The keyway slots of
both the impeller and the shaft must match. This must be done vertically.
Figure 8.2. Inserting the shaft through the impeller.
The use of a working table with a hole in it and a crane are suggested.
Lubricate with grease or oil the inner diameter of the impeller and the outer
diameter of the shaft.
To Next Page
Loading...
