Ruide Disteo 23 - Power; 9 Calibration; Calibrate I Angle

13
8.5 Power
To set parameters related to power.
SlepTime
Time to enter to sleep
mode if no operation.
Off Time
Time to power off if no
operation.
9. CALIBRATION
This program is to calibrate the errors and correct
additive constant.
9.1 Calibrate i Angle
i angle is also referred to the vertical index
difference.
Step 1: On Face Left, collimate the crosshair
center in a collimator, and adjust the focus until
it is clear. Press OK to proceed to next step.