Ruijie Reyee RG-RAP52-OD - Installation Environment Requirements; Ventilation; Temperature and Humidity

Hardware Installation and Reference Guide Preparing for Installation
9
 Direct or indirect contact with a wet object (or your finger) on the high voltage and power
line can be fatal.
 Please observe local regulations and specifications when performing electrical operations.
Relevant operators must be qualified.
 Carefully check for any potential hazards in the working area such as damp/wet ground or
floors.
 Find the location of the emergency power supply switch in the room before installation. Cut
off the power supply first in case of an accident.
 Be sure to make a careful check before shutting down the power supply.
 Do not place the device in a damp/wet location. Do not let any liquid enter the chassis.
 Keep the AP far away from grounding or lightning protection devices for power equipment.
 Keep the AP away from radio stations, radar stations, high-frequency high-current devices,
and microwave ovens.
2.2 Installation Environment Requirements
For normal operation and prolonged service life of the access point, the installation site must
meet the following requirements.
2.2.1 Ventilation
The access point adopts natural cooling. Reserve a sufficient clearance around the access
point to ensure proper ventilation.
2.2.2 Temperature and Humidity
See the following table for temperature and humidity requirements.
Table 2-1 Temperature and Humidity Requirements
Temperature
Humidity
–30°C to +65°C (–22°F to +149°F)
10% to 95%RH (non-condensing)
To ensure the normal operation and service life of the AP, maintain appropriate temperature
and humidity in the equipment room. Improper room temperature and humidity can cause
damage to the device.
 High relative humidity may affect insulation materials, resulting in poor insulation and even
electrical leakage. Sometimes it may lead to changes in the mechanical properties of
materials and corrosion of metal parts.