Hardware Installation and Reference Guide Installing the AP
19
2. Mounting the AP on a Vertical Pole
(1) Thread the band clamp through the hole on the back panel of the AP.
(2) Wrap the band clamps around the pole and pull it tight. The installation is complete.
3.5 Bundling Cables
Caution
The power cords and other cables should be bound in a visually pleasing way.
Make sure that the twisted pair cables at the connectors have natural bends or bends of
large radius.
Do not over tighten cable bundle as it may reduce the cable life and performance.
The steps for cable bundling are as follows:
(1) Bundle the drooping part of the cables and place the bundle as near the ports as possible.
(2) Route the cables under the AP and run them in straight line.
3.6 Checklist After Installation
(1) Checking the AP
Verify that the external power supply matches with the requirement of the AP.
Verify that the AP is securely fastened.
To Next Page
Loading...
