Hardware Installation and Reference Guide Installing the AP
12
The power supply and required current are available in the installation site.
The selected power supply modules meet the system power requirements.
The installation site meets the cabling requirements of the AP.
The installation site meets the site requirements of the AP.
The customized AP meets the client-specific requirements.
3.3 Precautions
The outdoor access point can be mounted on a wall or a pole with a diameter ranging from 50
mm to 70 mm (1.97 in. to 2.76 in.). If the diameter of the pole is out of this range, please
prepare a hose clamp that can hold the pole. The thickness of the hose clamp should be at
least 2.5 mm (0.10 in.). The installation site is determined by the technical personnel who
conducts a site survey.
Please make sure that the installation site meets with the following requirements in 2.2
Installation Environment Requirements and observe the following precautions:
Do not power on the AP during installation.
Install the AP in a well-ventilated location.
Do not subject the AP to high temperature.
Keep the AP away from high voltage cables.
Do not expose the AP in a thunderstorm or strong electric field.
Cut off the power switch before cleaning the AP.
Do not wipe the device with a damp cloth.
Do not wash the device with liquid.
Do not open the enclosure when the AP is working.
Secure the AP tightly.
The device should be installed at a height beyond the reach of the human body.
3.4 Installing the AP
Note
Install the device in a manner that maximizes the coverage area of the antenna.
The schematic diagram provided is for reference purposes only. The actual product
should be installed based on its physical specifications and design.
To Next Page
Loading...
