Ruijie Reyee RG-RAP52-OD - Introduction to the eWeb GUI; Single Management Webpage

Hardware Installation and Reference Guide Installing the AP
14
3.4.2 Connecting the Ethernet Cable
Caution
Ensure that the RJ45 connector of the Ethernet cable is properly connected to the AP.
Incorrect connection of the RJ45 connector may result in abnormal network connection. When
removing the Ethernet cable, first pull it out from the waterproof silicone slot, and then
disconnect the RJ45 connector from the AP.
(1) Push the back cover of the AP downwards to remove the back cover.
(2) Remove the silicone pad on the device.