Ruijie Reyee RG-RAP52-OD - Adding Network Devices

Hardware Installation and Reference Guide Debugging
21
4 Debugging
4.1 Setting up Configuration Environment
Use a 24 V non-standard PoE adapter or PoE power source to supply power to the device.
 Before powering on the device using a 24 V non-standard PoE adapter or PoE power
source, verify that the power cord is properly connected, and that the configuration
environment meets the safety requirements.
 Before performing debugging over a serial port connection, verify that both the PC and the
PoE switch are properly grounded.
4.2 Powering on the AP
4.2.1 Checklist Before Power-on
 Verify that the access point has adequate earth ground.
 Verify that the power cord is properly connected.
 Verify that the input voltage meets with the requirement of the access point.
4.2.2 Checklist After Power-on
 Verify that there is system log printed on the terminal interface.
 Verify the LED status.