Cookbook FAQs About Reyee AP Login
4
1.4 What Can I Do If I Fail to Log In to the Eweb Management System?
(1) Check that the network cable is properly connected to the LAN port of the device and the corresponding
LED indicator blinks or is steady on.
(2) Before accessing the configuration GUI, configure automatic IP address assignment (recommended), so
that the server with DHCP enabled can automatically assign an IP address to the PC. To allocate a static IP
address to the PC, set the IP address of the PC on the same network segment as the IP address of the
management interface.
(3) Run the ping command to test the connectivity between the PC and AP.
(4) If the fault persists, restore the AP to factory settings.
To Next Page
Loading...
