Cookbook Configuration
41
○ To configure the master device, select Network and choose Network > Radio Frequency.
○ To configure the slave device, select Devices, select the target device in the device list, and choose SN >
Radio Frequency.
In standalone mode, choose WLAN > Radio Frequency.
Select the best channel identified by Wi-Fi Moho or other Wi-Fi scanning App. Click Save to make the
configuration take effect immediately. More devices in a channel indicate more severe interference.
Instruction
The available channel is related to the country or region code. Select the local country or region.
Configure radio frequency parameters on the Radio Frequency page and click Save.
Table 1-2 Description of Radio Frequency Information
Set this parameter according to your location.
2.4G Channel Width/5G
Channel Width
Different products and different regions may have different channel
width. If the interference is severe, select a lower channel width to
avoid network suspension. The AP supports the channel width of
20 MHz and 40 MHz. You are advised to select 20 MHz channel
width. After changing the channel width, click Save to make the
configuration take effect immediately.
Limit the number of connected clients. The AP that is associated
with a large number of clients has lower performance, affecting
user experience. After the threshold is configured, new clients over
the threshold are not allowed to access the Wi-Fi network. You can
To Next Page
Loading...
Need help?
General
