RG-ES206GS-P Series Switches Hardware Installation and Reference Guide Preparing for Installation
12
and a completely electrically isolated unit. Conducted interference occurs when interference is transferred from
one unit to another through cables which are usually electromagnetic wires or signal cables connecting the
source and the sensor. Conducted interference often affects the power supply of the switch, but this can be
controlled by a filter. Radiated interference may affect any signal path in the equipment, and is difficult to shield.
Interference prevention measures should be taken for the power supply system.
Keep the grounding device of the switch far away from the grounding device and lightning grounding device
of the power equipment.
Keep the switch far away from the high-power radio transmitter, radar launch pad, and high-frequency
large-current devices.
Take electromagnetic shielding measures when necessary.
2.3 Tools
Table 2-1 Tools
Phillips screwdriver, slotted screwdriver, related copper and fiber-optic
cables, bolts, diagonal pliers, cable ties
Specification
The RG-ES2 series switches are delivered without a tool kit. Customers need to get ready the tools.
To Next Page
Loading...
Need help?
General