Hardware Installation and Reference Guide Installing the Device
14
3.3 (Optional) Installing the Hard Disk
Application Scenario
The RG-NSEC-HDD-1T hard disk can be configured for the device to store logs and report data.
Precautions
Pay attention to the following:
Install the hard disk when the device is powered off. Otherwise, the hard disk will be damaged.
Do not cover the hole on top of the hard disk.
Do not press down on the hard disk.
Do not drop, shake, or vibrate the hard disk. When handling the hard disk, hold it by its sides.
Do not touch PCB components with hands or tools.
Procedure
(1) Loosen the two fixing screws of the hard disk on the rear of the device when the device is powered off.
Figure 3-1 shows the position of the fixing screws of the hard disk.
Figure 3-1 Position of the Fixing Screws of the Hard Disk
(2) Remove the hard disk panel.
(3) Insert the hard disk.
(4) Fasten the fixing screws.
To Next Page
Loading...