Hardware Installation and Reference Guide Commissioning
19
(2) Turn on the power switch of the firewall.
4.2.3 Checklist After Power-On
Check the status of the PWR indicator on the device.
Table 4-2 PWR Indicator Status
The power supply is working normally.
The power supply fails or is not turned on.
4.3 Configuring the Product
Open a browser on the management PC, enter https://192.168.1.200 in the search box, and press Enter. Then,
log in to the web interface of the firewall to configure services.
Caution
By default, the prefix https must be used. If http://192.168.1.200 is used, you may fail to log in.
For details about device configuration, see User Manual of the required version.
To Next Page
Loading...