Ruijie RG-WALL 1600-Z3200-S - Device Commissioning and Configuration; Configuration Environment Setup; Powering On and Initial Configuration

Hardware Installation and Reference Guide Commissioning
18
4 Commissioning
4.1 Setting Up the Configuration Environment
Prerequisites
The Z3200-S firewall provides the default configuration, as described in Table 4-1.
Table 4-1 Factory Settings of the Device
DHCP
By default, the DHCP service is not enabled.
Login Address
Default address: https://192.168.1.200
Account and Password
Default account: admin
Default password: firewall
Management Port
Port 0/MGMT
Procedure
Use a network cable to connect port 0/MGMT on the firewall to the management PC.
Figure 4-1 Connecting the Network Cable
By default, the DHCP server function is enabled on port 0/MGMT. In this case, the local NIC of the management
PC can automatically obtain an IP address from the firewall to communicate with the firewall. Therefore, you do
not need to manually configure the IP address.
4.2 Powering on and Starting the Device
4.2.1 Checklist Before Power-On
 The device is properly grounded. (The three-core power supply and grounding connector are properly
grounded.)
 The power cord is properly connected.
 The power voltage meets the device requirement.
 The Ethernet cable is properly connected.
4.2.2 Powering on and Starting the Device
(1) Turn on the switch of the external power supply.