Hardware Installation and Reference Guide Installing the Device
15
3.4 Installing the Device at the Specific Position
The Z3200-S firewall can be installed in a standard cabinet. If no cabinet is available, the device can be installed
on a workbench.
3.4.1 Installing in a Cabinet
Application Scenario
When a standard cabinet is configured, the fixed accessories delivered with the device can be used.
The Z3200-S firewall is designed based on a standard cabinet. You can use the fixed accessories as required.
Prerequisites
Before installation, check the following items:
The cabinet has been properly secured.
The device installation position in the cabinet has been planned.
Procedure
(1) Install the mounting brackets on both sides of the device according to the Mounting Bracket Installation Guide
in the package contents.
(2) Install the cage nuts on both sides of the device.
(3) Lift the device by both sides and push it horizontally into the cabinet.
(4) Secure the left and right mounting brackets of the device to the front of the cabinet to fix the device in the
cabinet.
Follow-up Procedure
After installation, check the following items:
The device is securely installed in the cabinet.
About 1 U space is reserved above and below the device to facilitate heat dissipation.
No objects around the device hinder heat dissipation.
3.4.2 Installing on a Workbench
Application Scenario
In many cases, a standard cabinet is unavailable. In such cases, you can simply place the device on a clean
workbench.
Prerequisites
Before installation, check the following items:
The workbench has been properly grounded.
The workbench is clean, sturdy, and stable.
Procedure
(1) Paste the four rubber pads delivered with the device on the holes at the four corners of the bottom of the
device.
(2) Place the device on the workbench.
Follow-up Procedure
To Next Page
Loading...