Do not turn on the aircraft when it is on desk or hollow wooden floor.
They will amplify the small vibrations into high-frequency vibrations,
which will cause the gimbal cannot work.
Do not interfere with the gimbal by putting external forces or
picking up the aircraft during calibration. Otherwise, the gimbal will
stop to work.
Camera Guideline:
Please take off the gimbal camera cover before flight.
When taking off from grass or sand, please place the aircraft on
the landing pad or cardboard to keep it level.
①
②
On the sand
On the grass
F11GIM2 User Manual
Copyright ©2022 Ruko All Rights Reserved. 25
③
④
On the hollow wooden floor On the desk
Picking up the Aircraft
(during self-inspection)
Touching the camera
To Next Page
Loading...
