Copyright ©2021 Ruko All Rights Reserved. 17
The aircraft will automatically return to the Take-off Point when the battery level is
low. There is two modes in low battery RTH.
When in low battery, it will return to the 30m (98 ft) RTH altitudes above the
Take-off Point, the user can cancel RTH by pressing the RTH button on the APP or
press RTH button on the remote controller, you can cancel RTH and fly it within a
radius of 30m (98 ft) from Take off Point.
When in super low battery, it will return to the 30m (98 ft) RTH altitudes above the
Take off Point, then landing, the user can't cancel RTH but can control the direction
to avoid obstacles while landing.
U11Pro User Manual
5.2 Return to Home
Ruko U11 Pro drone doesn't have obstacle avoidance.
DO NOT turn off the remote control while flying.
The aircraft automatically flies back to the Take-off Point when Smart RTH is initiated, the
aircraft enters Low Battery RTH or Failsafe RTH the during the flight.
Waiting for GPS signal
8
D:0.0m H:0.0m VS:0.0m/sDS:0.0m/s
N
S
M E
If the GPS signal is sufficient, Smart RTH can be used to bring the aircraft back to the Take
off Point.
Smart RTH is initiated either by tapping in RUKO GPS APP or by pressing the RTH button on
the remote controller.
Exit Smart RTH by tapping in RUKO GPS or by pressing the RTH button on the remote controller.
The default RTH altitude is 20m (65.6 ft) . Tap the button to enter to close beginner mode, then
set the return altitude as you want.
If the altitude of the drone is less than 20m (65.6 ft) , it ascends to the 20m (65.6 ft) RTH altitude and
then flies back to the Take-off Point.
Smart RTH
Low Battery RTH
Low Battery RTH is triggered when the Intelligent Flight Battery is depleted to the point that
the safe return of the aircraft may be affected.
To Next Page
Loading...
