Starting the Motors
Push the joysticks into 5 & 7’o clock position to start
the motor, when the motor start to rotate, please
release the joysticks.
Stopping the Motors
After the motor starts rotating, there are two ways to stop:
After the Aircraft takes off, push the throttle stick to the
lowest position and operate the Aircraft to land until the motor
stops, then release the joystick.
Push the joysticks into 5 & 7’o clock position. When the flight is
not taking off, Push the joysticks into 5 & 7'o clock position to start
the motor. After the motor is turned off, please release the joystick
immediately.
Manually Land the Aircraft
When you need to manually land the Aircraft, continue to push the
Transmitter throttle lever downwards. Do not release the throttle
lever during landing until the Aircraft lands and the motors stop.
U11PRO User Manual
or
43
Copyright ©2023 Ruko All Rights Reserved.
When the Aircraft's flight state is tilted and unstable, please
land the Aircraft on a level ground for gyroscope/horizontal
calibration.
When the drone is in GPS mode, if it does not find enough GPS
signals, the drone cannot be unlocked to take off. Please place
the drone in an open environment to search for GPS signals.
②
②
①
①
6.4 Manual Starting/Stopping the Motors
Please choose a flat ground to land. Avoid causing damage to
the drone.
To Next Page
Loading...
