RED
From the component :
Probes of the tester should be applied on to the relate
d connectors as shown on the
pictures.
Salt Sensor
Sketch at the side show the connectors of the
salt sensor on the electronical card. Probes of
the tester should be applied on to the related
connectors.
F
rom the component :
.
Salt sensor can also be measured from the water softener
when the salt sensor assemblied on the water softener.
CN5.1 – CN5.2
0
Ω There is no salt
∞ Ω There is salt.
Electronic cart
connectors
BLACK
RED
CONNECTORS SHOULD BE MEASURED
60
To Next Page
Loading...
