Russell Hobbs RHDW1 - Page 64

KONNEKTÖR
O
N/OFF BUTTON
When the button pressed
0 Ω
( can not be measured from the electronical card)
Probes of the tester should be applied on to the relate
d connectors as shown on the
pictures.
DOOR SWITCH
From the electronical card
CN2.9 – CN2.2
0 Ω ( DOOR İS
CLOSE )
Above sketch show the connectors of the door switch on the
electronical card.
From the component :
Probes of the tester should be applied on to the relate
d connectors.
ELECTRONIC CARD
CONNECTOR
CONNECTORS SHOULD BE MEASURED
PURPLE
BROWN
61