Ryobi RM300E - Cutting Deck Front-to-Back Adjustment

25
Maintenance
1
2
2
1
1 2 3 4 5 6 1 2 3 4 5 6
11
10
9
3.2 - 9 mm
> 3.2 - 9 mm
3.2 - 9 mm
NOTE: The front tip of the blade should be
between 3.2 and 9 mm lower than the rear
tip.
NOTE: If the distance between the front and
rear tip of the blade is greater than 9 mm,
front-to-back adjustment is necessary.
9. Turn the adjustment nuts clockwise to
raise or counterclockwise to lower the
back of the cutting deck.
NOTE: Make sure to turn the
adjustment nuts on both sides equally
to prevent throwing off the side-to-side
measurement again.
Measure the distance between the
blade tips again. Continue to adjust and
measure until the front tip is between 3.2
and 9 mm lower than the rear tip.
10. Without moving the adjustment nuts,
tighten the jam nuts to secure the
adjustment nuts in place.
11. Lower the side discharge chute. Make
sure that it is properly closed.