Ryobi RM300E - Replacing the Mower Blade

27
Maintenance
1
2
2
3
2
1
4
REPLACING THE BLADE
1. Engage the parking brake, stop the
blades, turn off the product, and remove
the start key.
2. Loosen the cable lock, and disconnect
the cutting deck cables.
3. Set the cutting deck to the lowest
position.
4. On each side of the cutting deck, remove
the two hitch pins and washers securing
the cutting deck to the mower. Slide the
cutting deck out of the mower, and turn
the deck upside down.
WARNING: Keep bare hands and feet
away from the blades. Wear non-slip, heavy-
duty gloves when handling the blades.
1
p.20