900 Convertible Top Troubleshooting Guide
4.
Tonneau cover catches going up
-
“‘snaps” when opening
-
Tonneau latches misaligned?
Adjust striker and latch as per Service Manual
8:5
Cabriolet, pages 127-l 28.
Make sure to check the Tonneau cover latch adjustment with top fully raised,
because the 5th bow pushes the Tonneau cover down when the top is fully
raised.
Make sure that Tonneau latch pin
does not catch or bind in one
these areas
/L
~.
5. Grinding/ticking when Tonneau goes up
-
Tonneau motor not fully engaged?
Replace Tonneau motor assembly. Recheck cable adjustment. See pages
224-2 of Service Manual
8:5
Cabriolet.
Check emergency release handle cable adjustment as described in Opera-
tional Problem 3C.
4
06/09/97
To Next Page
Loading...
