5-4 Audio
AM/FM/Single-CD Audio System 3
33
3
The radio will operate only when the ignition switch is in the “ACC” or “ON” position.
¢ Radio operation
500023
(1)
(6) (5)
(2) (3) (4)
(1) SCAN button
(2) Power switch, Volume control, Bass/
Treble control and Fader/Balance
control dial
(3) Tuning buttons
(4) FM/AM selection button
(5) Preset buttons
(6) Tone/Balance button
q Power switch and volume/bass/tre-
ble/fader/balance control (PWR/
VOL)
The dial (2) is used for both power (ON/
OFF) and volume control. The radio is
turned ON and OFF by pushing the dial
and the volume is controlled by turning the
dial.
s Tone and balance control
The “VOLUME” control knob normally
function as volume control. This knob be-
comes a control for Treble, Bass, Fader or
Balance when you select the appropriate
audio mode.
Choose desired volume level for each
mode by turning the “VOLUME” control
knob. The control function returns to vol-
ume control mode after approximately 5
seconds.
To change control modes: Each brief
press of the “T/B” button changes control
A1910BE-A-GSAAB.book Page 4 Tuesday, September 6, 2005 8:37 AM
To Next Page
Loading...
