Seat, seatbelt and SRS airbags 1-5
1
– CONTINUED –
Seat heater 3
Driver’s side
1) HI – Rapid heating
2) LO – Normal heating
Front passenger’s side
1) HI – Rapid heating
2) LO – Normal heating
The seat heater operates when the igni-
tion switch is either in the “ACC” or “ON”
position.
To turn on the seat heater, push the “LO”
or “HI” position on the switch, as desired,
depending on the temperature. Selecting
the “HI” position will cause the seat to heat
up quicker.
The indicator located on the switch comes
on when the seat heater is in operation.
When the vehicle’s interior is warmed
enough or before you leave the vehicle,
be sure to turn the switch off.
Each active head restraint is ef-
fective only when its height is
properly adjusted and the driver/
passenger
sits in the correct posi-
tion on the seat.
If your vehicle is involved in a
rear-end collision, have an autho-
rized Saab dealer inspect the ac-
tive head restraints.
The active head restraints may
not operate in the event the vehi-
cle experiences only a slight im-
pact in the rear.
The active head restraints may be
damaged if they are pushed hard
from behind or subjected to
shock. As a result, they may not
function if the vehicle suffers a
rear impact.
1
2
100708
1
2
100709
A1910BE-A-GSAAB.book Page 5 Tuesday, September 6, 2005 8:37 AM
To Next Page
Loading...
